Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
Problems about Periodic Conditions in the tutorial model “Periodic Boundary Condition”
Posted 2013/02/11 5:10 JST RF & Microwave Engineering 8 Replies
Please login with a confirmed email address before reporting spam
Hi all,
Recently I confront one confusion about periodic conditions in the tutorial model - Periodic Boundary Condition. In Periodic Condition, it selects only boundaries 1 and 6 which are parallel with the yz-plane. As you know in the model, the cube should be a repeated cell and certainly repeated on the xy-plane both in the x direction and in the y direction. However, boundaries 1 and 6 only correspond to x direction. So what about repetition in the y direction?
Then I try to select both boundary 1, 6 parallel with yz-plane and boundary 2, 5 parallel with xz-plane in the Periodic Condition. But some problem occurs just as follows:
Errors during multiphysics.
Failed to find destination boundaries or destination selection empty
- Feature: Periodic Condition 1 (pc1)
I don't know why this happens and how to set Periodic Condition that means a repeated cell in the xy-plane both in the x direction and in the y direction.
Thank you so much.
Recently I confront one confusion about periodic conditions in the tutorial model - Periodic Boundary Condition. In Periodic Condition, it selects only boundaries 1 and 6 which are parallel with the yz-plane. As you know in the model, the cube should be a repeated cell and certainly repeated on the xy-plane both in the x direction and in the y direction. However, boundaries 1 and 6 only correspond to x direction. So what about repetition in the y direction?
Then I try to select both boundary 1, 6 parallel with yz-plane and boundary 2, 5 parallel with xz-plane in the Periodic Condition. But some problem occurs just as follows:
Errors during multiphysics.
Failed to find destination boundaries or destination selection empty
- Feature: Periodic Condition 1 (pc1)
I don't know why this happens and how to set Periodic Condition that means a repeated cell in the xy-plane both in the x direction and in the y direction.
Thank you so much.
8 Replies Last Post 2015/04/10 21:29 JST