技術情報とプレゼンテーション

クイック検索

資力

ホワイトペーパーとアプリケーションノート

研究開発におけるマルチフィジックスシミュレーションの具体例

さまざまな業界のエンジニア, 研究者, 科学者がマルチフィジックスシミュレーションを使用して革新的な製品の設計とプロセスを研究および開発しています. COMSOL カンファレンスで発表したテクニカルペーパーやプレゼンテーションからインスピレーションを得てください. 以下の選択項目を参照するか, クイック検索ツールを使用して特定のプレゼンテーションを検索するか, アプリケーション領域でフィルタリングします.

COMSOL コンファレンス 2020 論文集を見る

すべて

Bengaluru 2023

ヨーロッパ 2020

The Effect of Composition on the Role of Evaporation During Oil Recovery by Combustion

N. Khoshnevis Gargar[1], A. Mailybaev[2], D. Marchesin[2], H. Bruining[1]
[1] Delft University of Technology, Delft, The Netherlands
[2] Instituto Nacional de Matematica Pura e Aplicada, Rio de Janeiro, Brazil

One of the methods to recover oil from medium and low viscosity in complex reservoirs uses air injection leading to oil combustion. In this case the oxygen in the air burns the heavier components of the oil, generating a heat wave leading to vaporization of lighter components. The ... 詳細を見る

High Curvature Bending of Ultra-Thin Chips and Chip-on-Foil Assemblies

D. van den Ende[1]
[1]Holst Centre / TNO, Eindhoven, The Netherlands

Ultra-thin chips of less than 20µm become flexible, allowing integration of silicon IC technology with highly flexible electronics. This combination allows for highly intelligent products of unprecedented thinness, flexibility and cost. Examples include sensor systems integrated into ... 詳細を見る

Theoretical Study of Phase and Amplitude Characteristics of Microwave Coplanar Delay Line Containing Thin Ferroelectric Layer

V. Nikolaevtsev[1], S. Yankin[2], S. Suchkov[1], D. Suchkov[1], A. Litvinenko[1]
[1]Saratov State University, Saratov, Russian Federation
[2]Joint International Laboratory LICS/LEMAC, IEMN UMR CNRS 8520, EC Lille, France

We theoretically studied the microwave coplanar line of different geometry based on MgO substrate with a thin (30 nm) ferroelectric layer under the external electric field using the environment of 3D modeling in COMSOL Multiphysics®, RF Module, Frequency Domain. Frequency dependence of ... 詳細を見る

Influence of Electrode Kinetics on Lithium-ion Battery Characteristics

H. Machrafi[1,2], S. Cavadias[2]
[1]University of Liège, Thermodynamics of Irreversible Phenomena, Liège, Belgium
[2]University Pierre et Marie Curie, Laboratoire des Procédés Plasma et Traitement de Surface, Paris, France

The purpose of this work is to show whether an important difference in Lithium solid concentration and electrolyte concentration can be observed in a Lithium-ion battery model, when considering either the Butler-Volmer kinetics or the Tafel kinetics for describing the electrode kinetics ... 詳細を見る

Simulation of Thermal Transport Based Flow Meter for Microfluidics Applications

E. Byas[1], A. Arevalo[1], I.G. Foulds[1]
[1]King Abdullah University of Science and Technology, Thuwal, Saudi Arabia

COMSOL Multiphysics® is used to simulate a thermal transport based flow sensor, which will be embedded in a micro-channel of a Poly-methyl methacrylate (PMMA) based microfluidic device. The channel height is 100μm and for simulation purposes the lengths has been set to 1.2mm. The heater ... 詳細を見る

Thermal Integration of Coupled SOFC System with a High-Performing Metal Hydride Storage

A. Mossadegh Pour[1], A. Dhira [1], R. Steinberger-Wilckensa[1]
[1]Department of Chemistry, University of Birmingham, Edgbaston, Birmingham, United Kingdom

Auxiliary Power Units can play an important role in reducing vehicle emissions, especially in diesel and kerosene driven vehicles. In conventional vehicles the electricity supply comes from a generator that is directly coupled to the propulsion engine. New generation of fuel cell APUs ... 詳細を見る

$Numerical Analysis of Perforated Microring Resonator Based Refractive Index ...$

Numerical Analysis of Perforated Microring Resonator Based Refractive Index Sensor

M. Gabalis[1], D. Urbonas[1], R. Petruskevicius[1]
[1]Institute of Physics of Center for Physical Sciences and Technology, Vilnius, Lithuania

In this work perforated microring resonator based refractive index sensor is presented. Numerical analysis of the microring using COMSOL Multiphysics® was performed. From transmission spectra sensitivity and quality factor of our proposed structure were evaluated. It was shown that ... 詳細を見る

Modeling of Charge Transport in Ion Bipolar Junction Transistors

A.V. Volkov[1], K. Tybrandt[1], I.V. Zozoulenko[1], M. Berggren[1]
[1]Organic Electronics, ITN, Linköping University, Norrköping, Sweden

Modeling of an ion bipolar junction transistor (IBJT) is performed using the COMSOL Multiphysics® software. Our model describes the IBJT which was developed and characterized [1]. The IBJT under consideration consists of an anion-selective collector and emitter, a cation-selective base ... 詳細を見る

Modeling of the Material/Electrolyte Interface and the Electrical Current Generated During the Pulse Electrochemical Machining of Grey Cast Iron

O. Weber[1], A. Rebschläger[1], P. Steuer[1], D. Bähre[2]
[1]Center for Mechatronics and Automatization, Saarbrücken, Germany
[2]Institute of Production Engineering, Saarland University, Saarbrücken, Germany

The Pulse Electrochemical Machining is especially suitable for the precise production of complex geometric contours with high precision and high surface quality demands in series manufacturing. During this process, the negative structure of an electrode is copied to the workpiece without ... 詳細を見る

Optical Forces and Torques Acting on Non-spherical Metallic Nanoparticles

M. Siler[1], O. Brzobohaty[1], V. Karasek[1], P. Zemanek[1]
[1]Inst. Scientific Instruments of the ASCR, Brno, Czech Republic

Metallic nanoparticles (NPs) are nowadays used in various areas of biology, chemistry or physics. Focused laser beams, optical tweezers, may be used to manipulate such NPs. However, experimental studies showed that there is a discrepancy between their predicted and observed behavior. ... 詳細を見る

最初

前

2751–2760 of 5677

次

最後