技術情報とプレゼンテーション

随着我国国民经济的持续高速发展，生活与生产的用电量越来越大，电力行业的规模日益增大。电力设备在不正常工作时，大多会产生电弧电晕，通过检测电晕电弧等目标，就可以获知电力系统设备的损害程度。然而，目前并没有对真实的电弧电晕目标进行非光子计数方式的定量化研究。本文作者研制了一套紫外外波段的面阵成像探测系统，对实验室人工制造的高电压电弧电晕目标进行了相关的分析与实验研究。 利用 COMSOL Multiphysics® 的等离子体物理场接口的 DC 放电接口，对实验所用的天梯仪器的放电行为建模，分子碰撞数据选择大气压下的空气模型，对电晕放电辉光主要贡献的成分N2+ ... 詳細を見る

Lithium ion battery safety problem has attracted the whole world’s attention essentially after the explosion of Samsung Note 7. This work mainly deals with the study of the generation, characteristics and prevention measures of the battery fire. Firstly, the heat generation rate of ... 詳細を見る

摘要：油气勘探开发实践表明，主要油气层段中会存在 1.0m 以下的薄油气层。地质研究及试油试气结果证实，如果措施得当，这类薄储层也能获得较好的产能。为了研究高分辨率阵列感应测井仪器在含薄夹层地层中的测井响应特性，基于 COMSOL 软件 AC/DC 模块中的磁场模块，建立高倾角含层内夹层的三维地层模型，在改变目的层厚度 H、倾角 θ 及层内夹层厚度 Hj 等参数的情况下，计算低阻围岩情况下（围岩电导率 0.1S/m，目的层电导率 0.01S/m）阵列感应仪器发射源位于不同位置h时的测井响应，通过 LiveLink™ for MATLAB® ... 詳細を見る

电力传送中经常遇到导线周围金属体连续分布的电荷的电场电势分布问题，其中线电荷的电场分布非常典型, 对于实际情况，当导体靠近导线，因物体形状的不同，其表面产生不同的电荷分布。 解决方案 1 实际情况是三维问题，而三维几何体表面电场分布很难推出解析解，分解成二维模型并验证其表面电荷分布，再通过 COMSOL Multiphysics® 建立三维模型进行仿真计算。 2 对于一般的有限元编程繁琐，计算量大，不可视化，在 COMSOL 中可以不用人工编程，通过绘图功能，可以绘出几何体表面电场线图，与解析解进行对比。 模型设计 1 二维模型中无限长导线用细长线代替 ... 詳細を見る

In recent years, fire and explosion accidents of mobile phones and electric vehicles are very common. If the heat generated by the battery cannot be dissipated in time will cause the battery temperature rise, or even thermal runaway. Therefore, it is necessary to decrease the heat ... 詳細を見る

A new method is proposed to study battery thermal behavior under nature convection condition, especially focusing on temperature rising and inhomogeneity of battery. Using porous electrode theory, an electrochemical and homogenization heat source thermal coupling model and an ... 詳細を見る

Iodine absorber is a widely used purification equipment for purifying air in a nuclear power plant. In China, the common type is Ⅱ iodine absorber. Impregnated activated carbon is the main absorber within the iodine absorber. Because of the decays exothermic of radioactive iodine, heat ... 詳細を見る

When the production capacity of micro chemical plants is increased by numbering-up approach, it is important to realize the uniform flow distribution among the parallelized microreactors. In addition, a blocked microreactor needs to be identified as early as possible to achieve the ... 詳細を見る

Introduction: A metal film whose thickness is smaller than the skin depth, is of high transmission in the visible and half-transparent in the near infrared. However, when the film is divided into discrete nano-strips (i.e. array), an enhanced anomalous reflection and suppressed ... 詳細を見る

The performance of Li-ion battery is known to be dependent on the thickness direction distribution of binder volume fraction. The distribution is determined by drying process of electrode ink, which contains large active material and small binder. With the aim of predicting binder ... 詳細を見る