Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Equation based solution of system of PDEs. Example sought after.

Please login with a confirmed email address before reporting spam

The below post is related to an archived discussion


Hi, the cited reference to the Black-Scholes equation provided me with helpful introduction to using equation based modelling. However I would also like to study an example, - if any exist, - on how to implement a system of PDEs. More specifically I have a system of time-dependent DE derived from a model of a chemical sensor. The concentrations of many species, up to 10, are described by those equations, and and wnat to set up a time-dependent solution. It would be nice to be able to follow an example though. Any directions greatly appreciated. Regards Poul Ravn Sørensen Radiometer Medical ApS


1 Reply Last Post 2017/10/23 16:50 GMT-4
Jeff Hiller COMSOL Employee

Please login with a confirmed email address before reporting spam

Posted: 6 years ago 2017/10/23 16:50 GMT-4

Hello Poul Ravn,

When you have multiple variables involved in your own equations, you're often better off setting them up in a single physics interface than in separate ones. A couple of example with two variables (and two equations) are here: https://www.comsol.com/model/the-shallow-water-equations-202 https://www.comsol.com/model/electrical-signals-in-a-heart-981

But if it is chemical reactions that you are trying to model, you may want to look into the Chemical Reaction Engineering Module ( https://www.comsol.com/chemical-reaction-engineering-module ) as well, as it includes ready-to-use interfaces for this that will make your life much easier, especially when you are talking about 10 species.

Best, Jeff

-------------------
Jeff Hiller
Hello Poul Ravn, When you have multiple variables involved in your own equations, you're often better off setting them up in a single physics interface than in separate ones. A couple of example with two variables (and two equations) are here: https://www.comsol.com/model/the-shallow-water-equations-202 https://www.comsol.com/model/electrical-signals-in-a-heart-981 But if it is chemical reactions that you are trying to model, you may want to look into the Chemical Reaction Engineering Module ( https://www.comsol.com/chemical-reaction-engineering-module ) as well, as it includes ready-to-use interfaces for this that will make your life much easier, especially when you are talking about 10 species. Best, Jeff

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.