Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Inserting Sphere Particle 3D Simulation Problem

Please login with a confirmed email address before reporting spam

Hi

I am trying to model 3D laminar flow in T connection, as shown in attached pdf, in which the flow in one of the T branches is partially obstructed by a spherical obstacle. The question is, How I can insert the sphere particle inside the branch.

Thanks in advance.



0 Replies Last Post 2018/12/13 8:58 GMT-5
COMSOL Moderator

Hello Hazem El Sayed

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.