Here you will find presentations given at COMSOL Conferences around the globe. The presentations explore the innovative research and products designed by your peers using COMSOL Multiphysics. Research topics span a wide array of industries and application areas, including the electrical, mechanical, fluid, and chemical disciplines. Use the Quick Search to find presentations pertaining to your application area.
COMSOL-News-Magazine-2017
COMSOL-News-Magazine-2017-Special-edition-acoustics
COMSOL-News-Magazine-2016

Numerical Modeling and Performance Optimization Study of a Dehumidification Process in Nuclear Waste Storage

P. Geraldini[1]
[1]Sogin Spa, Rome, Italy

One of the main parameters to consider during the nuclear waste storage design phase is the drum corrosion risk. The humid-air corrosion models available in literature predict that, for carbon steel, the phenomena start to become appreciable for relative humidity (RH) values close to 65%. In general, the corrosion rate increases exponentially with relative humidity above the RH threshold. To ...

Modeling Bioelectrochemical Systems for Waste Water Treatment and Bioenergy Recovery with COMSOL Multiphysics®

T. Oyetunde[1], D. Ofiteru[1], J. Rodriguez[1]
[1]Masdar Institute of Science and Technology, Abu Dhabi, United Arab Emirates

Most conventional wastewater treatment processes are quite energy-intensive. Global wastewater production is increasing due to growth in population, industrialization, and urbanization, creating an urgent need for energy-efficient wastewater treatment technologies. Moreover, waste streams (industrial and domestic) have drawn renewed interest as resources for water, energy, and product recovery. ...

3D Modelling of Flow Dynamics in Packed Beds of Low Aspect Ratio - new

F. Alzahrani[1], F. Aiouache[1]
[1]Engineering Department, Lancaster University, Lancaster, UK

This work used the 3D CFD modeling to investigate non-uniform deactivation in packed bed reactors of low aspect ratios under steady state and dynamic operations. In order to explore the effects of condition of instability on local deactivation, detailed knowledge of flow dynamics (i.e. local structure of the packed bed, pressure drops and interstitial flow in the void space), heat and mass rate ...

Numerical Analysis of the Self-Heating Behaviour of Coal Dust Accumulations - new

D.Wu[1], E. Van den Bulck[1]
[1]Katholieke Universiteit Leuven, Department of Mechanical Engineering, KU Leuven, Belgium

Introduction Self-heating behaviour of dust accumulations is a multiphysics field coupled heat and mass transfer in the porous media. A typical experimental apparatus with a hot storage oven and mesh wire baskets has been taken as the study object. The influence of gas flow velocity, oxygen concentration and ambient temperature on the self-heating behaviour of the dry coal dust sample has been ...

A COMSOL Multiphysics® Study of the Temperature Effect on Chemical Permeation of Air Supply Tubes

R. Kher [1], C. Gallaschun [1], D. Crockill [1], R. Pillai [1], ,
[1] Department of Chemical Engineering, University of Pittsburgh, Pittsburgh, PA, USA

Air supply hoses are also predominantly used in the medical industry to aid in patient oxygen intake. In many situations, the outside of the hose can be contaminated with chemicals, especially if the hose lies on the ground in an environment where chemicals are easily found. Permeation and transport of chemicals into the walls of air supply hoses is a noteworthy problem in the chemical ...

Reacting Flows in Industrial Duct-burners of a Heat Recovery Steam Generator

G. Petrone[1], G. Cammarata[1], S. Caggia[2], and M. Anastasi[2]
[1]Department of Industrial and Mechanical Engineering, University of Catania, Catania, Italy
[2]Engineering Maintenance - ISAB Energy Services, Priolo Gargallo, Italy

In this study, COMSOL Multiphysics is applied in order to simulate reacting flows for duct burner systems arranged in the post-firing section of a Heat Recovery Steam Generator of a combined cycle power plant. Two- and three-dimensional simulations are carried out in order to investigate on operative conditions mainly responsible of duct burners overheating. The results are obtained for several ...

Heat Transfer Modeling of Steam Methane Reforming

E. Carcadea[1], M. Varlam[1], I. Stefanescu[1]
[1]National Research Institute for Isotopic & Cryogenic Technologies, Rm.Vâlcea, Romania

Steam methane reforming is a widely studied process because of its importance for hydrogen production. A two-dimensional membrane-reactor model was developed to investigate the steam-methane reforming reactions. The use of membrane as membrane-reactor separator offer us few advantages because it help in continuously removing the hydrogen from the reaction zone, shifting the chemical equilibrium ...

A Dynamic Simulation of Heterogeneous Catalysis with COMSOL Multiphysics® software

A. K. Patan [1], M. Mekala [1], S. K. Thamida [1],
[1] National Institute of Technology, Warangal, Telengana, India.

Reaction-Diffusion equation is simulated for heterogeneous catalytic reaction involving a porous catalyst particle surrounded by liquid reactants. COMSOL Multiphysics® software along with transport of dilute species module is used for this purpose. Global Variables such as reaction conversion are obtained through post-processing in COMSOL® software itself by evaluation of derived variables.

Model of Combustion Synthesis of Thermoelectric Calcium Cobaltates

J. Selig, and S. Lin
Lamar University, Beaumont, TX, USA

Self-propagating High-temperature Synthesis (SHS), a very economical synthesis of oxides was used in our lab to produce oxide materials. SHS process uses a highly exothermic reaction to convert reactants rapidly to pure products with minimal external energy input. This reaction is initiated by an igniter and reaction front propagates from the ignition through the rest of the sample. The fast ...

Simulation of the Plasma Generated in a Gas Bubble

L. Z. Tong[1]
[1]Keisoku Engineering System Co., Ltd., Tokyo, Japan

The plasmas generated in water involve various physical phenomena such as flows agitated by bubbles, high electric fields for breakdown, discharges in bubbles with size variation, and so on. In this paper, studies have been made on the simulation of plasmas generated in bubbles with size variation. The species taken in account include electrons, three kinds of ions, and ten kinds of neutral ...