P. S. Fodor, M. Kaufman
Cleveland State University, Cleveland, OH, USA
In this work we investigate computationally the use of spiral channels at Reynolds numbers from 25 to 900 as a mixing structure (Figure 1) using COMSOL Multiphysics, the CFD Module, and the Chemical Species Transport physics. In this system, the centrifugal forces experienced by the fluid as it travels along the curved trajectory induce counter-rotating flows. The presence of these transversal ...
E. Holzbecher , F. Sun ,
 German University of Technology in Oman, Muscat, Oman, Germany
 Georg-August-Universität, Göttingen, Germany
In boreholes nozzles have to be found advantageous to increase the infiltration rate of water into the subsurface ground. Studies and practice in the field shows that the infiltration of water into permeable aquifers can be improved, if the flow in the borehole is modified. Due to the nozzle the flow regime turns from linear to turbulent. CFD studies help to understand the physics of the ...
H. Rana ,
 Loughborough University, United Kingdom
This paper presents the investigation into the phenomena during batch reactor vessel mixing comparing agitation equipment; the Rushton turbine and the Marine propeller; in the production of bioethanol by yeast fermentation. The key factors addressed in selecting equipment were fluid vector flow, energy dissipation resulting in shear damage to yeast cells, agitation power consumption, critical ...
Weierstrass Institute for Applied Analysis and Stochastics (WIAS), Berlin, Germany
The Lévêque problem is an idealized simple situation concerning the influence of the boundary on the distribution of temperature or mass in Hagen-Poiseuille flow. Here, the performance of numerical solutions is examined for a range of Péclet numbers, spanning 11 orders of magnitude. We examine the Sherwood, resp. Nusselt numbers and confirm the cubic square rule for high flow ...
Y. M. S. El-Shazly, S. W. Eletriby
Alexandria University, Alexandria, Alexandria, Egypt.
The annular reactor is a very useful design to carry many chemical reactions. In this study, COMSOL Multiphysics® software was used to study the isothermal mass transfer from the inner side of the outer tube of the annular reactor in the range of 200
A. Kumar , C. Kaur , S. S. Padhee ,
 PEC University of Technology, Chandigarh, India
 IIT Ropar, Punjab, India
This paper explores the complexities of a dragonfly's flapping wing motion. It includes the literature as well as analytical results using simulations done in COMSOL Multiphysics® software. The study depicts the Fluid-Structure Interaction of the 2D wing (airfoil) with air, governed by Naiver-Stokes equations. The wing follows mathematical functions and is given motion similar to dragonfly's ...
E. Amores Vera, J. Rodríguez Ruiz
Centro Nacional del Hidrógeno, Puertollano, Spain
One of the most critical aspects on water electrolysis is gas-liquid separation, especially in systems with forced convection. The main problem of this kind of circulation is that a gas fraction could return to the electrolysis circuit. A suitable design of separator devices could be a solution in order to avoid a gas return to the electrolysis circuit. In this sense, the use of deflectors might ...
Steady and Unsteady Computational Results of Full Two Dimensional Governing Equations for Annular Internal Condensing Flows
R. Naik, S. Mitra, A. Narain, N. Shankar
Michigan Technological University, Houghton, MI, USA
This paper presents steady and unsteady computational results obtained from numerical solutions of the full two-dimensional governing equations for annular internal condensing flows in a channel. This is achieved by tracking the “sharp” interface while solving the flow fields using COMSOL Multiphysics® and MATLAB®. The unsteady wave simulation capability is used to predict heat-transfer rates ...
J. Park , M. P. Vidal-Meza , R. Zhou , S. Barua , C. Wang ,
 Missouri University of Science & Technology, Rolla, MO, USA
A simulation was performed to investigate the flow behaviors of drug delivery nanoparticles in a tumor-on-a-chip microfluidic device, which mimics a tumor cell having endothelial cells with micro-sized gaps. The Navier-Stokes equation and the convection-diffusion equation were used to model the flow field and the time-dependent particle distribution in the device, respectively. We investigated ...
Q. Guo , S. Ahmed ,
 EHC Canada, Inc., Oshawa, ON, Canada
 University of Ontario Institute of Technology, Oshawa, ON, Canada
Present study discusses a new method of how to apply numerical simulation in COMSOL Multiphysics® software to improve the accuracy of polymer melts viscosity measurements. The main emphasis is placed on evaluating the effects of entrance and exit geometry of a capillary rheometer on viscosity measurement. By combining experimental and COMSOL® simulation results, an accurate Bagley correction ...