J. Schumacher, P. Fideu, G. Ziegmann, and A. Herrmann
TU Clausthal-Institute of Polymere Materials and Plastic Engineering, Clausthal-Zellerfeld, Germany
CTC GmbH Stade, Stade, Germany
Faserinstitut Bremen e.V., Bremen, Germany
The current paper focuses on the creation of a consistent environment for the numerical prediction of the physical properties of polymer composite. A limitation factor for the successful simulation of composite processes is the correct estimation of the effective properties depending on several factors such as the constituents (fiber, polymer), the process setup. The numerical prediction of the ...
M. Cartas-Ayala, R. Karnik
Massachusetts Institute of Technology, Cambridge, MA, USA
Characterization of particles has numerous applications in science and diagnostics. Recently, particle passage through constrained microchannels has been proposed to characterize particles based on their passage velocity. Nevertheless, there is no clear understanding of how the physics in this system interact. Here we quantify the effects of the flow around the particle by simulating the passage ...
A Study of the Effects of Mounting Supports, and Dissipation on a Piezoelectric Quartz Double-Ended Tuning Fork Gyroscope
G. Choi, Y. Yong
Rutgers University, New Brunswick, NJ, USA
A COMSOL model of a piezoelectric quartz double ended tuning fork gyroscope was implemented. The gyroscope has two detection modes; the first mode detects the angular velocity about a z-axis perpendicular to the tuning fork plane (x-y plane), while the second mode detects the angular velocity about a y-axis that is the longitudinal axis along the length of the tuning fork. Eigenfrequency ...
3D Stationary and Temporal Electro-Thermal Simulations of Metal Oxide Gas Sensor Based on a High Temperature and Low Power Consumption Micro-Heater Structure
N. Dufour, C. Wartelle, P. Menini
LAAS-CNRS, Toulouse, France
Renault, Guyancourt, France
The aim of this work was to simulate the electro-thermal behavior of a micro-hotplate used as a gas sensor, in order to compare the obtained results with a real structure. The structure has been designed in 3D and a stationary and a temporal study has been realized.
This paper covers the following: * All-Optical Light Modulation of surface plasmon polaritons (SPPs) is achieved using asymmetric single nanoslits. A high on/off switching ratio of >20 dB and phase variation of >? were observed with the device lateral dimension of only about 2 ?m. * Efficient unidirectional excitation of SPP as well as beam splitting are achieved using the dielectric–film ...
P. Prema, Sakthivishnu.R, Sowmya. R, Chandra Devi K, Meenakshi Sundaram. N
PSG College of Technology, Coimbatore, Tamil Nadu, India
An artificial hand is the one that replaces the hand lost through trauma, disease, or congenital conditions. The proposed design is to simulate a sensor, used in prosthetic hand so as to measure the pressure required to hold the object, using COMSOL Multiphysics®. The physical parameters such as size, shape and mass of the object were optimized so as to hold an object. The weight of the object ...
V. Sista, and E. Bhattarchaya
Microelectronics and MEMS Lab
Department of Electrical Engineering
Indian Institute of technology Madras
A MEMS based Knudsen’s pressure gauge working in the range of 1e-5 mbar to 10 mbar is designed and simulated in COMSOL. The working principle is based on Knudsen’s forces that arise when two plates are held at different temperatures and their separation is comparable to the mean free path of the ambient gas molecules. The forces change the separation between the plates and capacitance between ...
王宗荣 [1,2], 王珊 ,
引言：柔性压力传感器在电子皮肤、智能假肢以及医疗监测诊断等领域发挥着十分重要的作用。因此压力传感器需要很高的灵敏度、较宽的敏感区间及稳定的性能。利用典型有机硅 PDMS 作为支撑层，聚合物 PEDOT: PSS 作为导电感应层制得的高度不均一微突结构的双压敏机制压阻传感器灵敏度达到了 851kPa-1。其探测范围广，性能优异，为解决目前压阻传感器中灵敏度低、敏感压力区间窄的难题提供了新思路。 COMSOL MULTIPHYSICS® 软件的使用：本文利用 COMSOL Multiphysics® 软件建立了不均匀微突结构的压阻式传感器模型，采用了结构力学与电流场两个物理场，通过电子接触对进行多物理场的耦合。研究在指定位移情况下，压阻式传感器电阻与电流的变化，从而得到灵敏度，验证不均匀微突结构压阻式压力传感器的双作用机制。同时，与均一微金字塔结构的压力传感器进行比较 ...
M. Baù, V. Ferrari, and D. Marioli
Department of Electronics for Automation, University of Brescia, Brescia, Italy
A contactless electromagnetic principle for the excitation of mechanical vibrations in resonant structures has been investigated. The principle relies on no specific magnetic property of the resonator except electrical conductivity and can be adopted for employing the structures as resonant sensors for measurements either in environments not compliant with the requirements of active electronics ...
F. Wittbracht, A. Weddemann, A. Auge, and A. Hütten
Department of Physics, Thin Films and Physics of Nanostructures, Bielefeld University, Bielefeld, Germany
In this work, we show that dipolar magnetic coupling can be used to control the particle flow through microfluidic structures without changing the state of motion of the carrier liquid. Also no external magnetic gradient fields are employed; the total external magnetic force applied is therefore zero. The theoretical idea will be tested experimentally. Here, additional effects originating from ...