Menu

Discussion Forum

New Discussion
フィルター

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

How to project "arrow surface" in a "cut plane" in Comsol

Posted 2016/06/10 2:04 GMT-4 1 Reply

Amin Hassanzadeh
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hi everyone,

I did simulation of flow in a 3D geometry in COMSOL and I generated a cut plane somewhere in the geometry where I want to see the velocity vectors in that plane. In order to do that, first I used "Arrow surface" and made the velocity vectors. However, I need to have the component of the velocity vectors which is on the surface of my plane. Do you have any idea how to do that?

Thanks!
1 Reply Last Post 2017/01/23 16:54 GMT-5
COMSOL Moderator

Hello Amin Hassanzadeh

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Lane Owsley
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 7 years ago 2017/01/23 16:54 GMT-5
You could subtract off the projection onto the normal.
You could subtract off the projection onto the normal.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content