Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
creating plot in comsol 3.5?
Posted 2011/01/19 5:44 GMT-5 Low-Frequency Electromagnetics, Results & Visualization 1 Reply
Please login with a confirmed email address before reporting spam
Hi,
I can't figure out how to create a plot in comsol. I have comsol 3.5, could someone explain what i have to click step-by-step in generator 2D from model library>AC/DC Module> Motors and Drivers to see plot which is showed on Figure 3-4 in documentation?
I can't figure out how to create a plot in comsol. I have comsol 3.5, could someone explain what i have to click step-by-step in generator 2D from model library>AC/DC Module> Motors and Drivers to see plot which is showed on Figure 3-4 in documentation?
1 Reply Last Post 2011/01/19 6:33 GMT-5
Please login with a confirmed email address before reporting spam
Posted:
1 decade ago
Hi Patryk,
I don't have the AC/DC module installed, so I can't exactly explain how to get your specific figure.
But in general in v3.5 to get plots, you would click on "postprocessing" in the menu bar and then on "plot parameters".
You can then choose between many plot types, such as surface plots, contours, arrows, streamlines, etc.
You can also choose, which parameter you'd like to plot or define your own expressions.
Did this help?
Best regards,
Juergen
I don't have the AC/DC module installed, so I can't exactly explain how to get your specific figure.
But in general in v3.5 to get plots, you would click on "postprocessing" in the menu bar and then on "plot parameters".
You can then choose between many plot types, such as surface plots, contours, arrows, streamlines, etc.
You can also choose, which parameter you'd like to plot or define your own expressions.
Did this help?
Best regards,
Juergen