Menu

Discussion Forum

New Discussion
フィルター

Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

PMLs setting in Solid Mechanics in COMSOL 41

Posted 2011/01/28 5:52 GMT-5 Structural Mechanics Version 4.1 0 Replies

Yong LI
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

I used the PMLs in solid mechanics, but I found the result is different from the one calculated from the same model using 3.5a.

I want to know how to fill the PML scaling factor, PML order, wavelength matched by the PML to get the same result to COMSOL3.5a.

the atttach files are two figures about the PMLs setting in COMSOL3.5a and COMSOL4.1.

any reply is appreciated.

0 Replies Last Post 2011/01/28 5:52 GMT-5
COMSOL Moderator

Hello Yong LI

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content