Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.
Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
Add apertures to parallel smooth surface
Posted 2017/06/12 0:54 GMT-4 Geometry, Structural Mechanics Version 4.2 0 Replies
Please login with a confirmed email address before reporting spam
I wang to create a 3D block with a crack plane going through. And I want to add apertures onto the two sides of the crack plane. However, I only know how to transform the aperture data into parametric surface. But how should I add it to the crack plane? I have tried to use extrude according to the aperture data. But my operation is not valid.
The attached screenshot shows what I did right now. The parametric surface and work plane are overlapped together. However, there is void gap between them. And what I want to do is fill this gap, to combine these parametric surface and work plane together.
Anyone knows how to do it?
Thx!
Attachments:
Hello Anderson Li
Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.
If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.