Menu

Discussion Forum

New Discussion
フィルター

Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

stop condition in fluid structure interaction (fsi) mode

Posted 2011/03/04 3:26 GMT-5 Microfluidics, Structural Mechanics Version 4.1 1 Reply

Zirui Li
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

I am trying to implement the stop condition in the fluid structure interaction(fsi) mode? My idea is to stop and remesh the geometry when the mesh of the fluid becomes too bad.
Howver when I follow the instructions on page 648 of Users mannual of version 4.1 by entering "mod1.ale.minqual-0.1" to the stop expression, the program refuse to run and report an error. If I remove the stop condition, it run well.
What is the expression for this in fsi mode?
Your help is highly appreciated.
A good weekend to all.

1 Reply Last Post 2011/03/21 5:37 GMT-4
Jérémie GIRARDOT
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 2011/03/21 5:37 GMT-4
Hi, I just do it the same and i think the problem is that you need a space character between the minus and the values.

Try with this expression : mod1.ale.minqual - 0.1

In my case, it is working. I did it in the following comsol model : www.comsol.fr/community/exchange/118/


regards
--
--
Jérémie GIRARDOT
PhD Student - Research Enginneer

Laboratoire PIMM - Procédés et Ingénierie en Mécanique et Matériaux
Arts et Métiers ParisTech / CNRS - UMR 8006
151, Boulevard de l'Hôpital
75013 Paris
FRANCE

phone : +33.1.71.93.65.62
mail : jeremie.girardot@gadz.org
website : pimm.paris.ensam.fr/
Hi, I just do it the same and i think the problem is that you need a space character between the minus and the values. Try with this expression : mod1.ale.minqual - 0.1 In my case, it is working. I did it in the following comsol model : http://www.comsol.fr/community/exchange/118/ regards -- -- Jérémie GIRARDOT PhD Student - Research Enginneer Laboratoire PIMM - Procédés et Ingénierie en Mécanique et Matériaux Arts et Métiers ParisTech / CNRS - UMR 8006 151, Boulevard de l'Hôpital 75013 Paris FRANCE phone : +33.1.71.93.65.62 mail : jeremie.girardot@gadz.org website : http://pimm.paris.ensam.fr/

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content