Menu

Discussion Forum

New Discussion
フィルター

Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Interpretation of model.geom().edgeCurvature()

Posted 2011/03/30 14:58 GMT-4 Interfacing Version 4.0a, Version 4.1 0 Replies

Gabriel Caron
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hi,

I'm trying to get the curvature of an edge with this command: ( see mph_prg Page 147 )

model.geom().edgeCurvature()


I made a few test, but I can't figure out the meaning of the value that are shown.



Thank you.



0 Replies Last Post 2011/03/30 14:58 GMT-4
COMSOL Moderator

Hello Gabriel Caron

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content