Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Boundary integration for a range of time

Please login with a confirmed email address before reporting spam

Hello everyone!

I have a doubt analyzing my postprocesing data. I´m simulating 4 walls like a room in 3D with radiative heat flux and ambient temperature whose change along the day in the heat transfer module in COMSOL 3.5a, so i´ve normal heat flux inside my walls in 24 hours in periods the one to one hour. I used the postprocessing menu the boundary integration but the integration is for a specific time... and my question is if i can do the integral of heat flux of one wall by the way, for example for a range of 1 to 4 hours... is it possible???

I really apprecite some advice,

Thank you,

Ivette. =)

2 Replies Last Post 2011/05/24 14:26 GMT-4
Ivar KJELBERG COMSOL Multiphysics(r) fan, retired, former "Senior Expert" at CSEM SA (CH)

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 2011/05/24 1:48 GMT-4
Hi

check to KB (knowledge Base of COMSOl) I believe to remember its described therein, it has been addresses a few time son the Forum already

--
Good luck
Ivar
Hi check to KB (knowledge Base of COMSOl) I believe to remember its described therein, it has been addresses a few time son the Forum already -- Good luck Ivar

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 2011/05/24 14:26 GMT-4
Thank you very much Ivar... I'll check it

Ivette.
Thank you very much Ivar... I'll check it Ivette.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.