Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.
Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
Initial value does not match input
Posted 2011/06/21 17:48 GMT-4 Studies & Solvers Version 4.1 0 Replies
Please login with a confirmed email address before reporting spam
I have input an initial temperature of 293.15 K (the default value) for my model, but when I noticed a strange hot spot showing up in my transient model (but not in the SS model) I checked the surface plot for t = 0 and saw that the hot spot was present there. Any thoughts on why this would occur and how to fix it? I am using the "extremely fine" mesh option right now.
In case it is relevant (it shouldn't be, but I don't know why such a simple problem would occur!), there are three material phases modeled by three different physics modules (Joule heating, heat transfer in solids, heat transfer in fluids). They are in thermal contact so I have set temperature BCs equal to the contiguous phase for each common boundary.
Thanks!
Hello Nancy Lape
Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.
If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.