Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.
Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
Re-setting displacments
Posted 2011/06/29 6:28 GMT-4 Structural Mechanics Version 4.2 0 Replies
Please login with a confirmed email address before reporting spam
I have a model of the ground that has a density and is subject to gravity (applied as a body force) I run a stationary model (in study 1) in order to allow the initial stresses in the model to develop, and obviously this causes some settling of the ground. My model is 16 km deep so this is around 40m.
What I then do (either as stationary or time dependant) is change something (in study 2) and see how the ground responds. This should be my starting point as in reality the ground is already in equilibrium so I am only interested in the displacements caused by this change.
In all other modelling software I have used there are options to reset displacements, or to set up an initial stress state so that there is no gravitational settling. I am at a loss to find any way to reset displacements in COMSOL, does anybody have any suggestions on how to achieve something like this?
Many thanks
Mark Thomas.
Hello Mark Thomas
Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.
If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.