Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
Comsol Multiphysics - Prepreg press (cure and compaction)
Posted 2011/07/16 9:07 GMT-4 0 Replies
Please login with a confirmed email address before reporting spam
Good morning. I am new to Comsol and interested in working on a prepreg (preform wet with resin) press model. The process is similar to a compression molding simulation. The prepreg solidifies to get a composite, under proper application of heat (cure cycle) and compaction (platen movement).
Can someone help me with cure modeling of composites. I am not even sure of implementing our own equations/models in comsol. How do I define a new equation and make it applicable to the model. I would be grateful if someone can help me with some references/suggestions/examples etc. Thank you.
Regards,
Venkata
Hello Venkata Bheem Reddy
Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.
If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.