Menu

Discussion Forum

New Discussion
フィルター

Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

MEMS Device Q Factor and Eigenvalues

Posted 2011/12/04 23:46 GMT-5 Version 4.2, Version 4.2a 0 Replies

Gabriel Miranda
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

I am working on modeling a 6 DOF device. When I run a TED analysis I get around 20 different eigenvalues. I know which are my sense and drive modes. My issue is that with each eigenvalue I calculate a different Q factor

Q = abs(img(lambda)/2/real(lambda))

But my Q varies from 8300 to 28000... So if I'm trying to find Q factor for the device, how do I know/decide which eigenvalue (or eigenvalue range) to choose?

Thank you so much in advanced!
0 Replies Last Post 2011/12/04 23:46 GMT-5
COMSOL Moderator

Hello Gabriel Miranda

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content