Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

hole on block

Please login with a confirmed email address before reporting spam

how can I make two holes on left and right side of block? please I need a detailed explanation. Thanks


5 Replies Last Post 2020/01/08 23:54 GMT-5

Please login with a confirmed email address before reporting spam

Posted: 4 years ago 2020/01/04 16:51 GMT-5

I'm working on 3D geom. kindly help

I'm working on 3D geom. kindly help

Please login with a confirmed email address before reporting spam

Posted: 4 years ago 2020/01/04 21:41 GMT-5

Interesting question. Did you try cubic beizer under more primitives in Geometry tab? Please keep us updated.

-------------------
Moin
Interesting question. Did you try cubic beizer under more primitives in Geometry tab? Please keep us updated.

Please login with a confirmed email address before reporting spam

Posted: 4 years ago 2020/01/06 7:17 GMT-5

Interesting question. Did you try cubic beizer under more primitives in Geometry tab? Please keep us updated.

actually i need box empty inside..... can I build the box by let the material of the block is air?

>Interesting question. Did you try cubic beizer under more primitives in Geometry tab? Please keep us updated. actually i need box *empty inside*..... can I build the box by let the material of the block is air?

Please login with a confirmed email address before reporting spam

Posted: 4 years ago 2020/01/07 9:39 GMT-5

I did it! pleas take a look :)

I did it! pleas take a look :)


Please login with a confirmed email address before reporting spam

Posted: 4 years ago 2020/01/08 23:54 GMT-5

Good job!

-------------------
Moin
Good job!

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.