Menu

Discussion Forum

New Discussion
フィルター

Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

How to simulate flexion/torsion?

Posted 2012/03/03 12:17 GMT-5 Version 4.2 1 Reply

Dar Gai Chan
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

I have just been tossed in the deep end of a new project and my PI wants me to simulate and optimize the geometry of a structure that will act like a spring by early this upcoming week. I have no experience with Comsol at all. Where can I find tutorials/tips/tricks on going about setting this simulation up?

Thank you for your input!
1 Reply Last Post 2012/03/04 12:16 GMT-5
Dar Gai Chan
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 2012/03/04 12:16 GMT-5
Can anyone please help me with this topic? Just a pointer in the general direction would be very very helpful. I am having a hard time even figuring out how to draw the spring.

Thank you!
Can anyone please help me with this topic? Just a pointer in the general direction would be very very helpful. I am having a hard time even figuring out how to draw the spring. Thank you!

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content