Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

sensitivity analysis of a transient problem

Please login with a confirmed email address before reporting spam

Hi

Do you know if it is possible to do sensitivity analysis in a transient problem without requiring matlab?

Thanks

2 Replies Last Post 2012/05/08 17:40 GMT-4
COMSOL Moderator

Hello Roger Samso

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.


Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 2012/05/08 17:16 GMT-4
I am after the same answer. If you found a solution please share. Thank you
I am after the same answer. If you found a solution please share. Thank you

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 2012/05/08 17:40 GMT-4
What version of COMSOL Multiphysics are you using? Version 4.2a has a sensitivity interface that allows formulation of a sensitivity analysis, and should operate with a transient problem.
What version of COMSOL Multiphysics are you using? Version 4.2a has a sensitivity interface that allows formulation of a sensitivity analysis, and should operate with a transient problem.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.