Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
Bar Necking Simulation
Posted 2021/03/15 21:15 GMT-4 Structural Mechanics Version 5.3 0 Replies
Please login with a confirmed email address before reporting spam
Hello everyone，
I have realized the bar necking case from the munual of Comsol. I think I can use this successful case as a basement to realize my consititutive model. But there are lot of errors in the result.
My hardening model is as below.
Where the k=400 MPa, sigma0=200 MPa, n=0.2.
I wonder for my hardening model if I can simulate the necking phenomenon using Comsol.
Hello Yongfan Guo
Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.
If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.