Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Flow rate determination in 3-D

Please login with a confirmed email address before reporting spam

Hi,

I am working on 3-D laminar flow with time dependent via rectangle geometry.
The Comsol version involved is Comsol 3.5.

I had refer some previous forum which discussed vividly about the technique to find out flow rate over the 3-D surface by using spf.U.

www.comsol.co.in/community/forums/general/thread/25455/
www.comsol.co.in/community/forums/general/thread/25967/

However, when I try out in my Comsol 3.5, under physics > Global Equations.
It pops out the error of:

Error: 9171
Syntax error in expression
-Expression: spf.u
-variable: E

Any advice for this? Or spf.U is not meant for Comsol 3.5?

Thanks and appreciate.

0 Replies Last Post 2012/06/06 23:17 GMT-4
COMSOL Moderator

Hello Xsu

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.