Menu

Discussion Forum

New Discussion
フィルター

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Contributing Boundary Conditions

Posted 2021/12/13 10:32 GMT-5 Electromagnetics, Low-Frequency Electromagnetics, General 0 Replies

Manuel Carrasco Yague
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hello,

I am calculating the impedance of a medium + cells between two surfaces that represent two electrodes.

I want to define a "distributed impedance" in both electrodes to represent the double layer capacitance, and then I want to set one of the surfaces as a "terminal" for my working electrode.

However, when I define the terminal, it overrides the distributed impedance, as its in the same surface. Is it possible to have two boundary conditions on the same surface?

Thank you for the help.

0 Replies Last Post 2021/12/13 10:32 GMT-5
COMSOL Moderator

Hello Manuel Carrasco Yague

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content