Menu

Discussion Forum

New Discussion
フィルター

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Boundary Load Change Having No Effect

Posted 2023/08/25 10:09 GMT-4 1 Reply

Munkyeong Jeong
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hi !

I'm having the same problem as this thread. (https://www.comsol.com/forum/thread/95741/Boundary-Load-Change-Having-No-Effect) Jeff has given an answer, but the link he posted is currently not working.

As for me, like the thread's question, no matter how much I change the current load, only the same amount of change appears. It is the same whether the load is set to 0.01 N or 1000 N.

Attachments:

1 Reply Last Post 2023/08/25 12:24 GMT-4
Jeff Hiller COMSOL Employee

Please login with a confirmed email address before reporting spam

Posted: 8 months ago 2023/08/25 12:24 GMT-4
Updated: 8 months ago 2023/08/25 12:27 GMT-4

See this other thread.

Bottom line: the solution is in fact different. It looks the same on screen because a different scaling is applied. Just refer to the numbers on the side of the colorbar when you plot the von Mises stress.

Jeff

-------------------
Jeff Hiller
See [this other thread](https://www.comsol.com/forum/thread/274932/thermal-expansion-problem?last=2021-01-13T20:25:37Z). Bottom line: the solution is in fact different. It looks the same on screen because a different scaling is applied. Just refer to the numbers on the side of the colorbar when you plot the von Mises stress. Jeff

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content