How to set the conditions for simulating the vibration of ultrasonic sensors

Please login with a confirmed email address before reporting spam

The excitation source is set to the specified displacement, and the pressure of solid mechanics is calculated. When calculating displacement, there is displacement only when the signal is input, and the subsequent displacement is always zero. How to solve this problem


1 Reply Last Post 2024/03/11 21:39 JST
Mark Cops COMSOL Employee

Please login with a confirmed email address before reporting spam

Posted: 2 months ago 2024/03/11 21:39 JST
Updated: 2 months ago 2024/03/11 21:39 JST

We would likely need to see the .mph file to provide specific guidance for this question. Can you upload it to the forum? Otherwise it might help to compare the model to models with similar setup like here: https://www.comsol.com/model/piezoacoustic-transducer-1477.

-Mark

We would likely need to see the .mph file to provide specific guidance for this question. Can you upload it to the forum? Otherwise it might help to compare the model to models with similar setup like here: https://www.comsol.com/model/piezoacoustic-transducer-1477. -Mark

Reply

Please read the discussion forum rules before posting.

Please log in to post a reply.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.