Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Piezoresistive cantilever beam

Yalamanchili Varshitha

Please login with a confirmed email address before reporting spam

I would like to get the plot of resistance change vs strain plot from a cantilever beam made of piezoresistive material. I have fixed an end of it and am applying the load at the other end. I have also taken one end as the ground and other end of it as a terminal with 1V.

Am I missing something. I am facing an issue in the plot. Any help would be appreciated.

thank you


2 Replies Last Post 2024/04/30 14:33 GMT-4
Yalamanchili Varshitha

Please login with a confirmed email address before reporting spam

Posted: 6 months ago 2024/04/30 0:18 GMT-4

I have applied time dependent boundary load at the end of cantilver beam and my convergence plot is looking somthing like this. Any help would be greatly appreciated. Thank you

I have applied time dependent boundary load at the end of cantilver beam and my convergence plot is looking somthing like this. Any help would be greatly appreciated. Thank you


Please login with a confirmed email address before reporting spam

Posted: 6 months ago 2024/04/30 14:33 GMT-4

You will need to post your (solution and mesh deleted) model in order to get any useful advice.

You will need to post your (solution and mesh deleted) model in order to get any useful advice.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.