Menu

Discussion Forum

New Discussion
フィルター

Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Properties of model

Posted 2013/02/24 7:53 GMT-5 Geometry, Materials Version 4.3a 3 Replies

Zdeno Zitny
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hey.

How can I check the properties of the model object?
For example, the current in the coil, or the radius of the circle, the properties of the materials.

Thank you.
3 Replies Last Post 2013/02/26 8:43 GMT-5
Ivar KJELBERG COMSOL Multiphysics(r) fan, retired, former "Senior Expert" at CSEM SA (CH)
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 2013/02/25 14:08 GMT-5
Hi

you can only post-process after having solved, or loaded the initial conditions, then you can use the Derived values node to integrate and interprete results around your domains or boundaries

--
Good luck
Ivar
Hi you can only post-process after having solved, or loaded the initial conditions, then you can use the Derived values node to integrate and interprete results around your domains or boundaries -- Good luck Ivar
Zdeno Zitny
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 2013/02/26 7:08 GMT-5
Thank you for your reply.

But I had in mind early formula
geom1.feature.create c1 = ('c1', 'Circle');
You can find out where the property value before calculating.

Thank you.
Thank you for your reply. But I had in mind early formula geom1.feature.create c1 = ('c1', 'Circle'); You can find out where the property value before calculating. Thank you.
Ivar KJELBERG COMSOL Multiphysics(r) fan, retired, former "Senior Expert" at CSEM SA (CH)
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 2013/02/26 8:43 GMT-5
Hi

you can do measurements in the graphics view see the ruler icon, but any "calculation" is performed on the discretized geometry, hence you need a mesh and at least loading in the initial conditions into the Data sets

--
Good luck
Ivar
Hi you can do measurements in the graphics view see the ruler icon, but any "calculation" is performed on the discretized geometry, hence you need a mesh and at least loading in the initial conditions into the Data sets -- Good luck Ivar

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content