Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.
-
Difference between defining one weak contribution at several points or several weak contributions with each located at one point
read0 Replies 424 ViewsVersion 4.3 Version 4.3a Version 4.3b Version 4.4 Modeling Tools & DefinitionsParameters, Variables, & Functions
Felix posted 1 decade ago
-
0 Replies 322 Views
Version 4.3b Results & Visualization
Afifa Basit posted 1 decade ago
-
1 Replies 532 Views
Version 4.3 Modeling Tools & DefinitionsParameters, Variables, & FunctionsResults & Visualization
SMHH posted 1 decade ago reply 1 decade ago by Eyal Spier
-
4 Replies 1636 Views
Version 4.4 Structural Mechanics
Georgios Drakopoulos posted 1 decade ago reply 1 decade ago by Georgios Drakopoulos
-
0 Replies 216 Views
Low-Frequency ElectromagneticsHeat Transfer & Phase Change
Ishant Jain posted 1 decade ago
-
I have two models, model 1 and model 2. When solving model 2, the initial value of model 2 is the result of model 1. should I set it ?
read0 Replies 318 ViewsVersion 4.3b Low-Frequency ElectromagneticsResults & VisualizationStudies & Solvers
Xin Wei posted 1 decade ago
-
0 Replies 191 Views
Darshan S posted 1 decade ago
-
0 Replies 287 Views
Nicolas Lhenry posted 1 decade ago
-
5 Replies 1403 Views
Version 4.4 MEMS & NanotechnologyMEMS & Piezoelectric DevicesMeshStructural Mechanics
Rajasekaran Ganeshkumar posted 1 decade ago reply 1 decade ago by Rajasekaran Ganeshkumar
-
1 Replies 404 Views
Version 4.3a Porous Media Flow
Raju Chowdhury posted 1 decade ago reply 1 decade ago by Gunnar Andersson
