Join the Conversation - COMSOL Discussion Forum

Note that while COMSOL employees may participate in the discussion forum, COMSOL^® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Problem with modeling coil
read

3 Replies 3522 Views

Przemek Kluska posted 2 decades ago 2010/07/06 0:53 JST reply 2 decades ago on 2010/08/05 17:31 JST by Ivar KJELBERG
How could I calculate the each element center of mass?
read

5 Replies 4622 Views

Park Seunggyun posted 2 decades ago 2010/08/04 17:23 JST reply 2 decades ago on 2010/08/05 17:29 JST by Ivar KJELBERG
Postprocessing - ploting difference in results between two time steps t1 and t2 in a transient run
read

1 Replies 1528 Views

Rakesh Dhote posted 2 decades ago 2010/08/05 14:19 JST reply 2 decades ago on 2010/08/05 17:27 JST by Ivar KJELBERG
Problems about connection between the Ver3.5 and Matlab
read

0 Replies 1522 Views

Zhe Wang posted 2 decades ago 2010/08/05 17:15 JST
related stress analysis
read

0 Replies 1445 Views

Park Seunggyun posted 2 decades ago 2010/08/05 14:44 JST
parametric solver
read

0 Replies 1951 Views

Asal Bidarmaghz posted 2 decades ago 2010/08/05 12:12 JST
How to apply pressure to a lean boundary
read

0 Replies 160 Views

xialu wei posted 2 decades ago 2010/08/05 8:44 JST
Solver Parameters.. doub
read

0 Replies 1625 Views

Nano posted 2 decades ago 2010/08/05 8:39 JST
Set a Rigid Body
read

2 Replies 4096 Views

Hesdras Santana posted 2 decades ago 2010/03/03 21:33 JST reply 2 decades ago on 2010/08/05 7:18 JST by Artem Korobenko
Cell layer simulation
read

0 Replies 1473 Views

Giovanni Battista Accetta posted 2 decades ago 2010/08/05 7:11 JST