Menu

Discussion Forum

New Discussion
フィルター

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

u-curved electrode

Posted 2016/11/01 1:29 GMT-4 1 Reply

Taghreed Said
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

how can i build u-curved cylinder in comsol?
1 Reply Last Post 2016/11/01 8:53 GMT-4
Jeff Hiller COMSOL Employee

Please login with a confirmed email address before reporting spam

Posted: 9 years ago 2016/11/01 8:53 GMT-4
Depending on the exact shape you want you can, take the union of two cylinders and a half torus or sweep a disc along a curve.
There's a very good chapter on geometry modeling in the Reference Manual for COMSOL Multiphysics. It starts on page 389 in version 5.2a. All manuals can be accessed through File> Help > Documentation. That chapter includes tutorials towards the end (page 492 and following).
Best regards,
Jeff
Depending on the exact shape you want you can, take the union of two cylinders and a half torus or sweep a disc along a curve. There's a very good chapter on geometry modeling in the Reference Manual for COMSOL Multiphysics. It starts on page 389 in version 5.2a. All manuals can be accessed through File> Help > Documentation. That chapter includes tutorials towards the end (page 492 and following). Best regards, Jeff

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content