Menu

Discussion Forum

New Discussion
フィルター

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Bistable beam simulation

Posted 2017/03/09 13:41 JST 1 Reply

Vasudha Agrawal
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hello,

I wanted to ask that is it possible to model the behavior of electrostatically actuated bistable beam (curved beam) in COMSOl. As I tried to do it using electromechanical physics but unable to find out snap-through and pull-in instability.


Regards,
Vasudha
1 Reply Last Post 2017/03/17 7:56 JST
Nagi Elabbasi Facebook Reality Labs
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 8 years ago 2017/03/17 7:56 JST
Check out the COMSOL Application Gallery model #16379 titled “Pull-in of an RF MEMS Switch”.
Check out the COMSOL Application Gallery model #16379 titled “Pull-in of an RF MEMS Switch”.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content