Menu

Discussion Forum

New Discussion
フィルター

Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

2D Axisymmetric electrostatic model

Posted 2011/05/03 13:43 GMT-4 Low-Frequency Electromagnetics, Heat Transfer & Phase Change Version 4.1 1 Reply

Osameh Ghazian
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

hi,

Is it possible to have a electric potential as a boundary in a 2d antisymmetric model ?

it gives me this error :Unknown parameter pairs", Feature: Electrostatics/

I have two parallel plates fixed in a constant voltage (-100V and 100V), now I want to half my model to reduce the number of nodes using symmetric condition. how can I do this?

Best
1 Reply Last Post 2011/05/16 13:00 GMT-4
Gadi Oron
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 2011/05/16 13:00 GMT-4
I see a similar error in heat transfer (ht) module when using 2 geometries.

No idea as to what is the source.

Ciao
I see a similar error in heat transfer (ht) module when using 2 geometries. No idea as to what is the source. Ciao

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content