Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

solving PDE's for bi-layer structure

Please login with a confirmed email address before reporting spam

Hello.

I have a model consisting of two bonded different layers. Physics in each layer is governed by a general PDE (different coefficients) form. I do not know how i can couple the PDE's, so that a flux at the interface remains continuous.

the condition i would like to apply at the interface has the form of A1 +B1*div(c1) = A2 + B2*div(c2), here A's and B's are constants, where c1 and c2 are evaluated at the common interface. I am sure my model does not work properly since i have tested it for bi-layered model with identical material properties, the results do not match the one layer model.

(Refer to the model attached) Any help is appreciated.

Thank You
Kumud


0 Replies Last Post 2011/09/30 15:27 GMT-4
COMSOL Moderator

Hello Kumud Kanneganti

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.