Menu

Discussion Forum

New Discussion
フィルター

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

U tube in a cylinder

Posted 2011/12/20 0:41 GMT-5 Geometry 4 Replies

Teuku Putra
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hello Sir,

Can you help how to make a U tube in a cylinder (U tube length is 4 m in 3 m height of a cylinder)

Thank you,
Tarp
4 Replies Last Post 2011/12/21 9:10 GMT-5
Ivar KJELBERG COMSOL Multiphysics(r) fan, retired, former "Senior Expert" at CSEM SA (CH)
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 2011/12/20 4:05 GMT-5
Hi

something like this you mean ? It's rather obvious so perhaps I must have missed something ;)

--
Good luck
Ivar
Hi something like this you mean ? It's rather obvious so perhaps I must have missed something ;) -- Good luck Ivar

Attachments:

Teuku Putra
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 2011/12/21 0:24 GMT-5
Thank you!

But I am using COMSOL 4.0 (4.0.0.925), would you please send me the mph file that I can open with that kind of version. I really apprecite it.

Tarp
Thank you! But I am using COMSOL 4.0 (4.0.0.925), would you please send me the mph file that I can open with that kind of version. I really apprecite it. Tarp
Ivar KJELBERG COMSOL Multiphysics(r) fan, retired, former "Senior Expert" at CSEM SA (CH)
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 2011/12/21 3:15 GMT-5
Hi

sorry I do not have that old version installed. I made a 1/2 torus, then a workplane and extruded 2 tubes from there

--
Good luck
Ivar
Hi sorry I do not have that old version installed. I made a 1/2 torus, then a workplane and extruded 2 tubes from there -- Good luck Ivar
Teuku Putra
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 2011/12/21 9:10 GMT-5
I did the U tube. Thank you so much for your help.

Tarp
I did the U tube. Thank you so much for your help. Tarp

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content