Menu

Discussion Forum

New Discussion
フィルター

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

How to generate flux in Permanent magnet after assigning N52 grade Ndfeb magnet

Posted 2021/06/25 4:38 GMT-4 Version 5.6 1 Reply

Dhiren Sondagar
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

What are the steps i follow to do simulation.

1 Reply Last Post 2021/06/29 3:25 GMT-4
Mark Harradine
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 4 years ago 2021/06/29 3:25 GMT-4

The attached model should get you started. I have pretty much used the default settings, but have added an Infinite Element domain on the model exterior to better simulate far field at the model boundary.

Perhaps the key step is to add a "Magnetic Flux Conservation" node in your MFNC physics.

The attached model should get you started. I have pretty much used the default settings, but have added an Infinite Element domain on the model exterior to better simulate far field at the model boundary. Perhaps the key step is to add a "Magnetic Flux Conservation" node in your MFNC physics.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content