Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
How to apply current？
Posted 2022/09/30 7:22 GMT-4 Electromagnetics, Low-Frequency Electromagnetics Version 5.6 1 Reply
Please login with a confirmed email address before reporting spam
I would like to ask how to apply current when two copper contacts are assembled together by extrusion and the voltage of the two contacts is the same? If the voltage of two contacts is set to the same value, will the electric field change when the motion separation is applied later? Thank you for paying attention to my problems. Thank you very much!
Please login with a confirmed email address before reporting spam
Sounds like you need to look into moving mesh for this. Maybe a little more detail on the setup can help.
-------------------René Christensen, PhD
Acculution ApS
www.acculution.com
info@acculution.com