Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
Problem with the imported mesh
Posted 2024/10/29 11:12 GMT-4 Wave Optics, Geometry, Mesh 0 Replies
Please login with a confirmed email address before reporting spam
Hi everyone,
I am trying to observe to Reflectivity spectrum of an FBG. If i build the correct geometry in one project (Let's call it Project A) and i run the "Boundary Mode Analysis" i get the right results. But if i build the exact same geometry in a second project, study the deformation of the geometry using the "Solid Mechanics" and then import it in a third project for the "Boundary Mode Analisys" (Project C), the results i get are wayyy different.
In the "Solid Mechanics" project i run a "Stationary" study step using a Point Load of 0 Newton. I should get the exact same geometry after the study and thus the exact same results of the Reflectivity spectrum. I dont know if i am doing something wrong, anything can help. Could be an exporting error? The study step for the Mode Analysis in project A and C are the same with the same parameters. :(
Hello Michele De Frenza
Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.
If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.