Menu

Discussion Forum

New Discussion
フィルター

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Help with mesh matching a reference sketch in COMSOL

Posted 2025/05/15 10:27 GMT-4 Heat Transfer, Mesh, Modeling Tools & Definitions Version 6.2 0 Replies

Luisa Schlumbohm
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hi everyone,

I'm new to COMSOL and need some help with the following task:

I’d like to create a mesh in my COMSOL-object (see picture) that matches the red lines shown in the sketch (see picture). Could someone kindly provide a step-by-step guide on how to achieve this?

Thanks a lot in advance!

Kind regards, Luisa

0 Replies Last Post 2025/05/15 10:27 GMT-4
COMSOL Moderator

Hello Luisa Schlumbohm

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content