Coil/Magnet Simulation

Please login with a confirmed email address before reporting spam

I am modeling an electro-magnet and comparing the results with some measurements. The results are fairly accurate except as you approach the area close to the boundary between the steel and the air domain.

I am just using a tetrahedral mesh. Is there a particular approach I need to take for this boundary?


Reply

Please read the discussion forum rules before posting.

Please log in to post a reply.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.