natural frequency

Please login with a confirmed email address before reporting spam

hi i am simulating a cylinder shape cavity to find the natural frequency. we did the experiment before in the laboratory but by simulating i can not get the exact result. i am wondering if i have applied the right boundary conditions to the model. the cavity put on the foam on the table during the experiment but in the simulation i have just drawn the cavity without foam underneath and applying fixed constraint boundary condition to the walls. what is the problem with my simulation and how can i get the exact result.



1 Reply Last Post 2025/11/06 3:39 GMT-5
Acculution ApS Certified Consultant

Please login with a confirmed email address before reporting spam

Posted: 6 hours ago 2025/11/06 3:39 GMT-5

It is not quite the same situation that you measure vs simulate. Perhaps start out by simulating with free conditions, just to see where you land. You can also add the foam in the simulation, perhaps via a spring condition or with explicit foam. Or fix the cylinder in the measurement.

-------------------
René Christensen, PhD
Acculution ApS
www.acculution.com
info@acculution.com
It is not quite the same situation that you measure vs simulate. Perhaps start out by simulating with free conditions, just to see where you land. You can also add the foam in the simulation, perhaps via a spring condition or with explicit foam. Or fix the cylinder in the measurement.

Reply

Please read the discussion forum rules before posting.

Please log in to post a reply.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.