アプリケーションギャラリ

This is an example of optimal control, where the input heating power to a rod is optimized to give a certain temperature on the outside of the rod. This is where the maximum water temperature occurs, while the minimum occurs at the center. Therefore this problem corresponds to the ... 詳細を見る

This example extends the corrosion protection system analysis of the single oil platform example by modeling the influence of multiple oil platforms placed in an array. The use of the Current Distribution on Edges, BEM interface significantly reduces the problem size and computational ... 詳細を見る

Communication masts usually have a framework with a bolted triangular lattice design. The diagonals of the framework are assembled from several parts and welded together. When operating under a given wind load at a specific location, the antenna’s total rotation angle should stay below ... 詳細を見る

次のモデルは, 流れてくる流体に対して直角に流路内に置かれた長い円筒を過ぎる非定常で非圧縮性の流れを調べます. 円筒は流れの中心からいくらかオフセットされており, 定常状態の対称的な流れを不安定にします. 周期的な流れのパターンが現れるのに必要なシミュレーション時間は予測が困難です. 重要な予測因子は, 円筒の直径に基づくレイノルズ数です. 値が 100 未満の低い場合, 流れは定常です. このシミュレーションでは, レイノルズ数は 100 に等しく, 発達したカルマン渦列が生じますが, 流れはまだ完全に乱流ではありません. 詳細を見る

In a cooling system, a microelectronic component has been identified as the critical link. Since the power is repeatedly switched on and off, the component is subjected to thermal cycling. As a results a crack grows through a solder joint and disconnects the chip from the printed circuit ... 詳細を見る

In this model you study the force-deflection relation of a car door seal made from a soft rubber material. The model uses a hyperelastic material model together with formulations that can account for the large deformations and contact conditions. 詳細を見る

This example models galvanic corrosion between two different phases in a magnesium alloy for a representative cross-sectional microstructure configuration. The Level Set interface is used here to model dissolution of a constituent phase leading to topological changes. The electrode ... 詳細を見る

An AC contactor is a particular type of magnetic switch device, which is activated by a primary coil fed by an alternating current. Unlike DC switches, such devices can suffer from a tendency to reopen when the AC current crosses zero. The addition of a shading coil that supports ... 詳細を見る

This example demonstrates how to model coupled flow, heat transfer, and structural deformation and stress in a pipeline network. Gravity loads from the pipe and fluid are also taken into account. 詳細を見る

In this model, a full transient analysis of a loudspeaker driver is performed, which allow the modeling of nonlinear effects. It extends the linear frequency domain analysis done in the Loudspeaker Driver tutorial model. The analysis accounts for nonlinear behavior of the soft iron in ... 詳細を見る