アプリケーションギャラリ

This example introduces three different models for a lateral flow assay for the detection of coronavirus antibodies. These models are as follows: 3D model for studying possible symmetries in the spreading of the liquid sample in the test strip. The 3D model shows that the flow is ... 詳細を見る

静磁気問題の例として, 馬蹄形の永久磁石をモデル化する方法を考えてみましょう. 1つの方法は, 磁石全体を強磁性体として扱い, 両端のセクションが異なる反対方向に事前に磁化されていると定義することです. 詳細を見る

This is one of the two models from the blog post about heat transfer in the subsurface: Coupling Heat Transfer with Subsurface Porous Media Flow Note: Poroelasticity is not included here. 詳細を見る

This example shows the modeling of a resin transfer molding (RTM) process for a wind turbine blade using the Two-Phase Flow, Level Set, Brinkman Equations interface. Resin is injected into a preform consisting of different composites with different anisotropic permeabilities. 詳細を見る

This tutorial demonstrates how to integrate multiple Lumped Battery models into the Electrical Circuit interface. Two batteries are connected in series. Each battery is protected by a shunt resistances that is activated if the battery state-of-charge reaches below a certain threshold ... 詳細を見る

このモデルは, 互いに等距離に配置された GaAs 柱で構成されるフォトニック結晶における波動伝播を調査します. 柱間の距離は, 光の波数と周波数の関係を決定し, 特定の波長の光が結晶構造内を伝播するのを防ぎます. この周波数範囲はフォトニックバンドギャップと呼ばれます. 特定の構造には複数のバンドギャップがあり, このモデルは結晶の最低周波数帯域のバンドギャップを抽出します. バンドギャップ解析には, 主に2つの複雑な問題があります. 1つは, GaAs の屈折率が周波数に依存することです. 2つ目は, ... 詳細を見る

This model studies the temperature effects on the viscoelastic stress relaxation in a long thick-walled cylinder. In particular, decay of the stresses under the influence of the temperature field during a period of two hours is studied. A four-term generalized Maxwell model represents ... 詳細を見る

In this example, the natural frequencies of a double hat beam are studied. The beam is made of two thin steel plates, joined together by spot welds along the flanges. The Spot Welds feature sets up multiple mesh-independent connections between the shells. 詳細を見る

This is a tutorial of a slot die coating process in 3D where the channel is obstructed. The example uses a two-phase flow phase-field method with a non-Newtonian power-law fluid. The effects on the film thickness of the channel obstruction can clearly be seen. 詳細を見る

Cryer's problem is a three-dimensional consolidation benchmark. A porous sphere is subjected to a uniform boundary pressure. The pore pressure at the center of the sphere rises due to the Mandel-Cryer effect that is captured by a two-way coupling between Darcy's law and solid mechanics. 詳細を見る