アプリケーションギャラリ

This example uses the Granular Flow interface to model the formation of the grain heap and then its subsequent spreading using a cylindrical roller. The roller has a combined rotational and translational motion. The resulting powder bed is then analyzed to determine its quality based on ... 詳細を見る

This presentation shows how to use the Optimization Module to fit a material model curve to experimental data. It is based on the hyperelastic Mooney-Rivlin material model example given in the Structural Mechanics users guide. 詳細を見る

This model illustrates the dynamics of a car door assembly during a slam event. The system consists of a car body, a door, and rubber seals. Contact pairs are defined between the car body, rubber seals, and the door. The rubber seal is modeled using a hyperelastic material model. A ... 詳細を見る

A Gaussian beam is incident on a 45-degree thin-film stack embedded in glass material prisms. The thin-film stack is designed from alternating high and low refractive index materials. The wave will be refracted at the Brewster angle at each internal interface. Thus, mainly p-polarized ... 詳細を見る

This tutorial series demonstrates how to import printed circuit board (PCB) data from the IPC-2581 file format and generate simulation-ready geometry. Key topics include selecting the import type, handling drill layers, creating simplified 3D components and pads, and previewing file ... 詳細を見る

This example uses the Granular Flow interface to model the fixed funnel method for calculating the angle of repose, where a funnel is kept at a fixed height. The funnel is first filled with grains which are subsequently released and collected as a heap. The resultant heap is then ... 詳細を見る

この例では, 水で満たされた貯水池の上に置かれた細い垂直シリンダーを調べます. 空気と水の界面の壁面接着と表面張力により, 水は流路を通って上昇します. 表面張力と壁面接着力は, MEMS デバイスのマイクロ流路を通じて流体を輸送したり, マイクロピペットを使用して少量の流体を測定, 輸送, 配置したりするためによく使用されます. 多孔質媒体を通る多相流や固体壁上の液滴も, 壁面接着力と表面張力が流れのダイナミクスに強く影響する例です. 壁面の接着力を正しくモデル化するには, 境界条件の扱いが重要です. 壁面の速度をゼロに固定すると, ... 詳細を見る

This tutorial shows how to set up a 3D simulation of rubber injection molding. A phase field method is used to track the interface between the rubber and the displaced air. The rubber is modeled as shear-thinning inelastic non-Newtonian power law fluid with a fluid-consistency ... 詳細を見る

This model aims to demonstrate how a multilayer insulation can affect the temperature distribution of a satellite orbiting around the Earth. It is based on the Spacecraft Thermal Analysis model available in the Application Library. 詳細を見る

This tutorial model of the Joule heating effect in a busbar demonstrates how to synchronize geometry between the AutoCAD® software and the COMSOL Multiphysics® software, how to modify the geometry from COMSOL Multiphysics®, and how to run a geometric parametric ... 詳細を見る