アプリケーションギャラリ

This is a benchmark model to test the numerical algorithms in the area of multibody dynamics. This model simulates the dynamic behavior of the slider crank mechanism. This mechanism goes through singular positions during its operation. The acceleration at a point is compared with the ... 詳細を見る

This model shows how to implement an anisotropic, incompressible, hyperelastic material for modeling soft collagenous tissue in arterial walls. The hyperelastic material model implemented is based on the articles: Holzapfel, G. A., Gasser, T. C., & Ogden, R. W. (2000), A new ... 詳細を見る

In this example, a spring-loaded valve-opening mechanism consisting of a rocker arm and a radial cam is studied. All of the system components are modeled as rigid and are connected through prismatic, hinge, and slot joints. The cam-follower connection as well as other joint connections ... 詳細を見る

This benchmark model computes the pressure in a system of outgassing pipes with a high aspect ratio. The results are compared with a 1D simulation and a Monte-Carlo simulation of the same system from the literature. 詳細を見る

This example models a small reverse osmosis water desalination unit. The unit consists of a spirally wound semi-permeable membrane through which the water is forced under high pressure. The membrane retains the salt, such that on the permeate side fresh water is produced and on the ... 詳細を見る

This example studies heat transfer in a square column. Cold and hot temperature conditions are applied to the boundaries. Due to the symmetry of the problem, the geometry is simplified to half of the square. The temperature field is compared with the analytic data. This example ... 詳細を見る

小型加熱回路は, さまざまな用途で使用されています. たとえば, 製造プロセスでは, 反応性流体を加熱します. このチュートリアルの例のデバイスは, ガラス板に堆積された電気抵抗層で構成されています. 回路に電圧が加えられると, この層によってジュール熱が発生し, 構造が変形します. 層の特性によって, 生成される熱量が決まります. このマルチフィジックスの例では, 加熱回路デバイスの電気熱生成, 熱伝達, 機械的応力と変形をシミュレートします. このモデルでは, 伝熱 (固体) インターフェースを, 電流 (積層シェル) ... 詳細を見る

A benchmark model for the fatigue module. A cylindrical test is subjected to non-proportional loading. Three stress based models: Findley, Matake, Normal stress, are compared to analytical values and to each other. The non-smooth behavior of the Matake model is captured and discussed. 詳細を見る

このチュートリアルでは, サーペンタイン型の流路パターンを用いた低温 PEMFC における電流分布について考察します. セルは対向流モードで動作し, 酸素と水素の入口流路は反対側に配置されます. セルが良好な性能を得るために自己加湿を利用するよう, 比較的乾燥した入口ガス組成が使用されています. 詳細を見る

This example uses the Electric Currents in Layered Shells interface and the Layered Shell interface to model a piezoresistive pressure sensor. The tutorial considers the design of the MPX100 series pressure sensors originally manufactured by Motorola Inc. Although the sensor is no ... 詳細を見る