アプリケーションギャラリ

This tutorial shows how to model the propagation of acoustic waves in large pipe systems by coupling the Pipe Acoustics interface to the Pressure Acoustics interface. The tutorial is set up in both the time domain and the frequency domain. 1D pipe acoustics is used to model the ... 詳細を見る

One-sided magnets are magnets designed to have both magnetic poles emerging from the same side of the magnet. This results in the magnetic flux being concentrated on one side of the magnet. These kinds of magnets are found in many applications from the common fridge magnet to particle ... 詳細を見る

This model demonstrates how the sun causes 1.75 arcseconds of deflection for rays grazing the sun's surface as observed from the earth. Einstein predicted this value after refining his theory of relativity during World War I. 詳細を見る

This example uses asymptotic techniques to study the radar cross-section (RCS) response of a conductive sphere. The selected physics interface transforms the incident plane-wave field on the boundaries to the far-field using the Stratton–Chu formula. The computed results are compared to ... 詳細を見る

The model demonstrates how to compute the induced voltage of a wire loop inside an airplane under different electromagnetic shielding conditions. 詳細を見る

Phase separation occurs when a binary system is quenched from its stable, homogeneous one-phase state into the two-phase region of its phase diagram. The spontaneous separation of two immiscible fluids is sometimes referred to as spinodal decomposition. Each phase tends to separate into ... 詳細を見る

リチウムイオン電池の負極グラファイト電極上の銅コレクターは, 過放電時に溶解することが確認されています. 溶解により集電体が不可逆的に損傷し, 溶解した銅イオンが再析出してデンドライトを形成する可能性があるため, 安全上の懸念事項となります. 電池は通常, 過放電を回避するために, セルレベルまたはパックレベルのいずれかで指定された電圧制限内で動作します. しかし, パック内では個々のセル間の電荷不均衡により, あるいはこのチュートリアルで部分的に調査するように, 単一の電池セル内の電極の局所的な不均一性により, 過放電が発生する可能性があります. ... 詳細を見る

In this example, monotonic and cyclic triaxial tests are simulated using the Hardening Soil Small Strain material model. The model captures the effects of small strain stiffness and hysteresis under cyclic loading. The stress-strain relationship matches the hyperbolic curve reported in ... 詳細を見る

In this model, compute the propagating modes in the chamber of an automotive muffler. The geometry is a cross-section of the chamber in the Absorptive Muffler example. The model’s purpose is to study the shape of the propagating modes and to find their cut-off frequencies. As discussed ... 詳細を見る

This example resembles the well-known double-slit interference experiment often demonstrated in schools with water waves or sound. The model mimics the plane-wave excitation with two thin waveguides leading to slits in a screen and computes the diffraction pattern on the opposite side of ... 詳細を見る