アプリケーションギャラリ

This model shows a setup of two parallel wires with a constant current running through both. Their cross-sections are successively reduced until a set force per unit length is reached. 詳細を見る

In this example, the importance of including elastic deformations when analyzing heavily loaded fluid-film bearings is investigated. The structural parts are modeled using the Solid Mechanics interface, while the pressure in the lubricant is determined by the means of the Hydrodynamic ... 詳細を見る

This model demonstrates how to define Earth properties that are spatially varying on the planet. A satellite in orbit experiences solar, albedo, and planetary infrared (IR) loads, where albedo and planetary IR can vary with latitude and longitude. In this example, these inputs are read ... 詳細を見る

In this first half of a two-part example, a 2D model of a trench-gate IGBT is built, which will be extended to 3D in the second half. In general, it is the most efficient to start with a 2D model to make sure everything works as expected, before extending it to 3D. The Caughey&ndash ... 詳細を見る

This model simulates an H-shaped micro-cell designed for diffusion-controlled separation. The cell puts two different laminar streams in contact for a controlled period of time. The contact surface is well-defined and, by controlling the flow rate, it is possible to control the amount of ... 詳細を見る

Interfacial failure or delamination in a composite material can be simulated with a cohesive zone model (CZM). A key ingredient of a cohesive zone model is a traction-separation law that describes the softening in the cohesive zone near the delamination tip. This example shows the ... 詳細を見る

This application presents an example of pressure driven flow and electrophoresis in a 3D micro channel system. Researchers often use a device similar to the one in this model as an electrokinetic sample injector in biochips to obtain well-defined sample volumes of dissociated acids and ... 詳細を見る

In this shape optimization example, the mass of a bracket is minimized by changing the size and position of a number of geometrical objects. The requirements give limits both on the lowest natural frequency, and on the maximum stress in a static load case. This means that results from ... 詳細を見る

真空乾燥は, 製薬業界や食品業界で, 湿った粉末から水や有機溶媒を除去するために頻繁に用いられる化学プロセスです. 真空乾燥システムを設計する際, エンジニアは製品の品質を高く維持しながら乾燥時間を最小限に抑えることを目指します. このモデルは, Nutsche 式フィルタードライヤーにおける真空乾燥を調査します. Nutsche 式フィルタードライヤーは, 湿ったケーキが充填された円筒形のドラムで構成されています. ケーキの上部は低圧のヘッドスペースにさらされ, 側壁と底壁は加熱流体にさらされます. 非常に低い圧力と高温で動作させることで, 液体の蒸発速度が増加し, ... 詳細を見る

この例では, フェーズフィールド損傷モデルを用いて, 切欠き付き穿孔板の脆性破壊をモデル化します. 板の形状は, 実験データから得られた寸法と材料特性に基づき, 混合モード破壊が誘発されるように設定されています. この例では, この種の問題に対して効率的かつ安定したソルバー構成を設定する方法を示します. 詳細を見る