技術情報とプレゼンテーション

High power-density electronic devices had achieved levels of heat generation that have exceed the current heat removal capacities. Due to the increase in power density of modern electronic chips, there is a need of a higher heat flux removal capabilities, and single-phase fluid-flow wavy ... 詳細を見る

Emerging battery technologies are addressing applications of renewable and fossil fuel energy sources since they can store and release energy on demand. In recent years significant strides have been made in lithium battery technology. Lithium batteries are the primary sources of power in ... 詳細を見る

An electrochemiluminescence (ECL) sensor was developed in a smartphone-based platform using a disposable disk-shaped carbon electrode. A time-varying square waveform potential was applied to the working electrode, and the current and ECL intensity data were measured. The applied ... 詳細を見る

One of the most destructive modes of corrosion of metals is localized corrosion. This can take many forms depending on the chemical and electrochemical environment of the metal. One important form is crevice corrosion, which occurs where two or more surfaces in close proximity lead to ... 詳細を見る

Working fluids (engine oil, transmission fluid, hydraulic fluid, coolants, etc.) become contaminated in use. To ensure that the equipment is not damaged by the contaminated fluid, the fluid is typically removed and replaced periodically. For large groups of machines, the used fluid is ... 詳細を見る

With the anticipated effects of global climate change upon us, induced by egregious CO2 emissions, it is imperative to implement technologies to close the carbon cycle. One potential technique to do this is storing the energy from intermittent sources (e.g. solar, wind, hydro) in the ... 詳細を見る

Neuromodulation, a closed-loop therapy that combines the recording and stimulation of neurons using implanted electrodes, is widely considered the future of care for many neurological diseases including epilepsy and Parkinson’s. Existing neuromodulation therapies, however, are limited by ... 詳細を見る

Lithium ion battery electrodes are porous composite film made up of two or three different types of solid material. Typically using the fabrication of the electrode, the solid powders (active material, binder and in most cases a conductive active) are dispersed in a solvent like NMP and ... 詳細を見る

Renewable energy sources such as solar and wind are intermittent in nature. Their effective utilization requires efficient, low cost energy storage systems to complement energy harnessing systems. The rechargeable flow batteries have emerged as the most suitable candidates due to their ... 詳細を見る

As modern electrical power networks grow to reduce costs to consumers, improve security of supply, and make better use of renewable energy, power electronic interfaces are set to become increasingly commonplace by allowing controllability, diversity in supply and demand, and the ... 詳細を見る