技術情報とプレゼンテーション

Introduction Velocity profiles in liquid films flowing over rotating conical surfaces are of considerable interest in industry. The efficiency of important process equipment, such as spinning cone columns, fluid degassers, centrifugal disc atomizers, centrifugal film evaporators, and ... 詳細を見る

Droplet–based microfluidics has received special research attentions in last two decades due to its superior control over fluid flow as well as other unique advantages[1]. By introducing two immiscible fluids into microfluidic systems, the reagent fluid is encapsulated inside discrete ... 詳細を見る

Numerical theory provides the basis for quantification of the accuracy and reliability of a FEM solution by error estimates on the FEM error vs. the mesh spacing of the FEM mesh. This paper presents techniques needed in COMSOL Multiphysics® software to perform computational studies for ... 詳細を見る

Engineering design studies of the feasibility of conversion of the High Flux Isotope Reactor (HFIR) from high-enriched uranium to low-enriched uranium fuel are ongoing at ORNL as part of an effort sponsored by the U.S. Global Threat Reduction Initiative program. HFIR is a very high flux, ... 詳細を見る

To the best of our knowledge, only few researchers have made attempts to minimize the erosion in bends by modifying the bend configuration in order to alter the particle-laden flow pattern to reduce the erosion. In this work, we revisited those previously proposed bend configurations to ... 詳細を見る

The block caving mine is considered by the mining industry as one of the natural replacements of the current open cut mines in the near future. The block caving technique is based on the extraction of small broken rocks, created by blasted initially large solid rocks, and the fracture of ... 詳細を見る

In this experiment, the performance of a Printed Circuit Heat Exchanger (PCHE) was studied using COMSOL Multiphysics® software. PCHEs are diffusion bonded heat exchangers containing semicircular, chemically etched flow paths. Helium was used as the working fluid on both the hot and cold ... 詳細を見る

Conventional swing is one phenomenon which a bowler uses to gain an advantage over the batsman. This study involved simulating conventional swing in the CFD Module of COMSOL Multiphysics® software and comparing the simulated results with experimental results of previous researchers. The ... 詳細を見る

Stockton University has one of the largest closed loop geothermal system in North America. It provides heating and cooling for the university academic facilities. The well field comprises of a grid of four hundred wells bored to a depth of 130m. The ground is composed of three aquifers ... 詳細を見る

Delayed Coking is a refining process, which takes heavy petroleum residue as a feed. A 2D axisymmetric stationary model was created to simulate this pre-run condition with nitrogen gas, as an attempt to calibrate the model before simulating with an oil residue. The single-phase laminar ... 詳細を見る